/ / / /
 

TECH: Revolver cassette

(click the images to enlarge)
(click the part numbers below in bold to purchase)

1. Hub shell
2. CrMo axle | #S2404
3. 6902 sealed bearing | #S2909
4. Tube spacer | #S2911
5. Lock nut (internal) | #S2912
6. 3/16" steel ball bearings (13 qty) | #S2913
7. Cone nut (non-drive side) | #S2914
8. Rubber seal (drive side) | #S2917
9. Steel spring | #S2900
10. Steel pawls (4 qty) | #S2901
11. Lock nut (non-drive side) | #S2915
12. Rubber seal (non-drive side) | #S2916
13. CrMo driver | #S2405
14. 1/8" steel ball bearings (38 qty) | #S2918
15. Cone nut (drive side) | #S2919
16. Lock nut (drive side) | #S2920
17. Rubber seal (driver) | #S2925
Revolver Cassette Hub: RHD, 36h, 9t driver

Drive Flange Diameter: 52mm
Non-Drive Side Flange Diameter: 52mm
Spoke Hole Diameter: 2.8mm
Drive Flange Offset: 27mm
Non-Drive Flange Offset: 27mm

Notes: To remove the axle from the hub both sides need to be completely disassembled. This will include extraction of the pawls and springs from the shell. The axle can be taken out at this point by tapping the end of the non drive side with a rubber mallet causing it to exit from the drive side of the hub.







 
Copyright © 2004
www.StolenBMX.com